Standard delivery: approx. 15–20 days.
Express delivery: approx. 10–15 days.
Aideepen 22.5W DIY power bank kit provides a digital-display charging module for building your own portable charger. Choose a white case kit, a black case kit, or the module-only option for your own project. Assembly and soldering are required; batteries are not included.
Specifications:
Maximum advertised charging output: 22.5W with a compatible charging protocol, device, cable, and battery setup.
USB-C bidirectional charging: up to 20W PD.
Connections: one USB-C input/output port, two USB-A output ports, and a Micro USB input.
Digital battery-percentage display.
Charging controller: IP5356.
Simultaneous output from multiple ports does not support fast charging.
Supplier-listed protection functions: overcharge, over-discharge, overvoltage, and overheating protection.
Battery requirements:
The case accommodates two compatible 3.7V 1260110 lithium-polymer cells. Batteries are sold separately, and actual capacity depends on the cells installed.
Lithium iron phosphate batteries are not compatible.
Dimensions:
Case exterior: approximately 145 × 67.5 × 27.5 mm.
Internal battery installation space: approximately 110 × 60 × 23 mm.
Mainboard: approximately 56.5 × 23.7 × 13.7 mm.
Technical data:
Micro USB input: 5V/2A, 9V/2A, or 12V/1.5A.
USB-C input: 5V/3A, 9V/2A, or 12V/1.5A.
USB-C output: 5V/3A, 9V/2.2A, or 12V/1.6A.
Fast-charging performance depends on the charging protocol supported by the connected equipment. Not every device supports the advertised maximum output.
Available variants and package contents:
White Kit: white case, charging module, USB-A to USB-C cable, connection wires, button, screws, and assembly pads/strips shown in the product photos.
Black Kit: black case with the same kit components as the White Kit.
Only Module: one charging module and two connection wires. Case and USB cable are not included with this option.
Batteries are not included with any variant. Assembled-product photos illustrate the finished result.
Assembly requirements:
This is an electronics assembly kit, not a ready-to-use power bank. Installation requires experience with lithium-battery electronics and soldering.
Follow the supplier's assembly instructions, observe the marked battery polarity, and use the specified parallel battery configuration, never a series connection. Incorrect wiring or inadequate insulation can damage the circuit and create a safety hazard.
Test the module and all charging functions before closing the snap-fit case. The case is not intended for repeated disassembly.
